6 wt for steelhead

Discussion in 'Steelhead' started by wanative, May 30, 2013.

  1. wanative

    wanative Member

    Joined:
    Jan 5, 2013
    Messages:
    51
    Likes Received:
    25
    Location:
    Custer, Wa
    I have a couple 6 wt. rods I'd like to try for steelhead this summer. Would they be adequate to handle 6 to 10 lb.fish? I do have a 8 wt. with a versi-tip line but I would prefer the lighter rod if feasible.
    I don't think the flies I use would cause a weight issue as far as casting the 6 wt.
    Thanks in advance for your input

    Fred
     
  2. Flyborg

    Flyborg Active Member

    Joined:
    Mar 17, 2006
    Messages:
    2,384
    Likes Received:
    666
    Location:
    Kalama, WA
    Yes. Just don't be afraid to put the power on the fish when you hook the big ones. It may feel like a lot, but it's pretty tough to break a good rod fighting a fish at a good angle.
     
    Grayone likes this.
  3. Evan Burck

    Evan Burck Fudge Dragon

    Joined:
    Jun 21, 2007
    Messages:
    6,575
    Likes Received:
    1,932
    Location:
    Duvall, wa
    Home Page:
    Why?

    An 8wt is a much better tool for the job. Being undergunned is infinitely less fun than having a bit of reserve power. And you're putting a wild fish in danger by going light and prolonging the fight. Not to say a 6 isn't enough.. I wouldn't use one on steelhead myself... But learn how they fight before going down in size.
     
    Dan Cuomo likes this.
  4. Andy D

    Andy D Active Member

    Joined:
    Dec 15, 2009
    Messages:
    193
    Likes Received:
    77
    Location:
    Des Moines, Wa
    I also have both six and Eight weights that I use for steelhead. I would use the eight weight early in the summer season when casting larger flies and sink tips, and then use the six weight latter in the summer and fall for small flies over low water conditions. Also I would not use the six weight if the system your fishing on has fish that average over six to eight pounds.
     
    fredaevans likes this.
  5. cuponoodle breakfast

    cuponoodle breakfast free bird

    Joined:
    Feb 26, 2003
    Messages:
    1,829
    Likes Received:
    490
    Location:
    western WA
    I use a 6wt for small water where the fish can't run very far AND where the odds of encountering a wild fish are nearly zero. If a river is big enough that the fish have room to run, or there's a decent chance of hooking wild fish, I'd take my 8wt.
     
    constructeur likes this.
  6. GAT

    GAT Dumbfounded

    Joined:
    Nov 16, 2012
    Messages:
    6,800
    Likes Received:
    4,950
    Location:
    Willamette Valley, OR
    Same here. Plus, on the smaller coastal rivers there's always a chance of catching a SRC and an 8wt for one of those guys is over-gunning.

    (When Sage first opened their doors, I bought their first model rod in a 6 weight and used it for just about everything... including steelhead. The rod had no trouble handling the fish. Of course the original model Sage rod is much different than what they sell these days.)
     
    Terry Bare likes this.
  7. Josh Stroud

    Josh Stroud Active Member

    Joined:
    Sep 29, 2012
    Messages:
    281
    Likes Received:
    108
    Location:
    WA
    I agree, the 6 will work. But why? I would go with the 8.
     
  8. David Dalan

    David Dalan 69°19'15.35" N 18°44'22.74" E

    Joined:
    Aug 30, 2007
    Messages:
    2,387
    Likes Received:
    1,098
    Location:
    Walla Walla, WA
    Maybe yes, maybe no.

    If in doubt, go up..I say!

    An old yarn says match the water not the fish. Certainly not always true (what is?), but explains why in some skinny water I do pull out the 4wt for steelhead. I'm talking creeks, and 24" is the general upper limit.
     
  9. KerryS

    KerryS Ignored Member

    Joined:
    Oct 19, 2001
    Messages:
    7,354
    Likes Received:
    2,673
    Location:
    Sedro Woolley, WA, USA.
    I use a 6 weight two hander for summers. I believe a 6 is enough rod for summer steelhead in the hands of a fisherman that has experience landing large fish. A heavier rod might be a better choice for someone that hasn't had a lot of experience catching steelhead.
     
  10. Josh Stroud

    Josh Stroud Active Member

    Joined:
    Sep 29, 2012
    Messages:
    281
    Likes Received:
    108
    Location:
    WA
    Good point David, the water can definetly matter. Quite different catching a steelhead in a creek vs a large river with strong current. I have had smaller salmon in strong running water feel much bigger than they do in a small creek/stream.
     
  11. David Dalan

    David Dalan 69°19'15.35" N 18°44'22.74" E

    Joined:
    Aug 30, 2007
    Messages:
    2,387
    Likes Received:
    1,098
    Location:
    Walla Walla, WA
    You make a good point here...I'm talking single handers. If the question is regarding 2 handers, then a 6wt would be fine, my goto is a 7wt (fast) two hander.

    Rule of thumb is 3 weights...I.e. 6wt 2 hander is = 9wt single, I thought.
     
  12. Evan Burck

    Evan Burck Fudge Dragon

    Joined:
    Jun 21, 2007
    Messages:
    6,575
    Likes Received:
    1,932
    Location:
    Duvall, wa
    Home Page:
    I catch steelhead on a 5wt two hander. But that rod has about as much power to fight fish as an 8wt single hander.
     
    constructeur likes this.
  13. Jamie Wilson

    Jamie Wilson Active Member

    Joined:
    Jun 30, 2006
    Messages:
    1,199
    Likes Received:
    195
    Location:
    Arlington WA
    The 6 two hander is probably 10'6 or longer right?
    Helps on the handling.
    The 8 can punch through just about anything.
     
  14. Jamie Wilson

    Jamie Wilson Active Member

    Joined:
    Jun 30, 2006
    Messages:
    1,199
    Likes Received:
    195
    Location:
    Arlington WA
    I would like to cast a 5 wt two hander.
    I've been thinking of getting one
     
  15. KerryS

    KerryS Ignored Member

    Joined:
    Oct 19, 2001
    Messages:
    7,354
    Likes Received:
    2,673
    Location:
    Sedro Woolley, WA, USA.
    I will agree that a 6 two hander is likely more capable than a 6 single but only because of its length. There is no way my 6 two hander is equal to a 9 single. In fact it can't even be compared to my 8 single.